Spread the love

We look at more high-ended bikes with our aspect keyboring or 2-piece cranks. Currently, there are different variations with paradox standard and these new designs, and it considers special to establish pass sensor. Look down for all the details, and keep in mind – if you don’t want to install Cadledal-Assoc Magnet and sensor you can always use throttle!

Do I have 2-piece crankset or outboard boots?

Probably not. These are still limited to unusual and high-value bikes. But there are some simple ways to check – our standard pedal-aid Mountain Mountain Mountains (Rider left side)

Square Ticks SPINDLE

This paddle is the ideal setup for magnets and easy installation of sensor – it installs with parts involving the kitte. Tepers differ by length manufacturer and by bike, so if the magnet fits a small loose, use hot glue to stay in spinders to move it.

Installation video: HTTPS: //youtu.bfyy / Vfyyveu9wr8 w

If you want to remove your cranks and bottom brackets and a “permanent” is installed, we provide hardware for it, but provides this problem with the easiest way. Minimum series is about size 28t, and the pass is engaged in a thick spindle below a magnet drive. The sensor is attached to the bracket cup. Call us for details: HTTPS: //youtu.bey/gfyre65Nagc

Square Ticks SPINDLE

“US” a piece-crank

Installs the correct parts with the general parts of this kitte. But they are uniformly shaped or very straight runs so are not very straight runs so the magnet takes a bit for pressing at the place.

Installation video: HTTPS: //youtu.bfyy / Vfyyveu9wr8 w

American BB

Outboard Crerating:

If you see that there is no exposed bracket spindle, you have a modern owner craky.

For this set you need to install the “driver’s right census” on the side of the pedal-aid sensor “Drive-side sensor” series. From April 2019, we are offering special split-disk magnets to installs the 4-Bolt (64BCD) and the bolt (74 BB BOLT (74 BB BOLT) to the condition of a devil. The minimum cheering size is about 22t.

For this, you want to use “Right hand “ The pedal-aid sensor is not included, “Left-handed” Sensor Kit. However censors look like the same, they read the direction of your pedaling, so it works only when founding in the right side.

To establish the installation here (for clarity, but will be better installed in one-bike in a magnet disk): HTTPS ://youtu.be/6949xzlnwggggggggg

If you want to remove your cranks and bottom brackets and a “permanent” is installed, we provide hardware for it, but provides this problem with the easiest way. The minimum cheering size is about 28t, a kiss of 28t and is for a bull cranks, pass sensor is involved in BB Cup. Call us for details: HTTPS ://youtu.belll1klulu188

No exposed spindle